self aligning ball bearings
This type of ball bearing is recommended when alignment of the shaft and housing is difficult and the shaft may flex. The outer ring has a spherical raceway and its center of curvature coincides with that of the bearing; therefore, the axis of the inner ring, balls and cage can deflect to some extent around the bearing center. Pressed steel cages are usually used. Since the contact angle is small, the axial load capacity is low. The permissible dynamic misalignment is approximately 0.07 to 0.12 radian (4 to 7 degrees) under normal loads.However, depending on the surrounding structure, such an angle may not be possible.
A self-aligning bearing is recommended when the alignment of the shaft and housing is difficult or when the shaft may bend during operation. Brda notes that similar to deep groove ball bearings, most self-aligning ball are for general use.
- Toyana 127P self aligning ball bearings
- 480 mm
- 790 mm
- 110 mm x 240 mm x 50 mm SKF 1322KM self aligning ball bearings
- 280.000 mm
- 420.0000 mm
- Toyana 129 self aligning ball bearings
- 140 mm
- 225 mm
- Toyana 1311K+H311 self aligning ball bearings
- 80 mm
- 140 mm
